Equipment reference / 0-551-325 0-553-103 0-704-006
Rytec Bantam hardware conflicts across manual and motorized lists
Compare conflicting fastener lengths, nut thread sizes and dome-plug diameters before choosing a replacement.
Identification details & limits
Reference identifier: 0-551-325 0-553-103 0-704-006. Compare each listed detail with the exact product and the source document. Do not submit a personal serial number or access code to this website.
- Rytec Bantam manual operation manual, May 25, 2000R0815007, May 25, 2000, PDF page 33 / printed page 29: Conflicting hardware · checked 2026-09-13 · R0815007, May 25, 2000 · Rytec
- Rytec Bantam manual operation manual, May 25, 2000R0815007, May 25, 2000, PDF page 35 / printed page 31: Nut-size conflict · checked 2026-09-13 · R0815007, May 25, 2000 · Rytec
- Rytec Bantam manual operation manual, May 25, 2000R0815007, May 25, 2000, PDF page 31 / printed page 27: Plug diameter · checked 2026-09-13 · R0815007, May 25, 2000 · Rytec
- Rytec Bantam motorized operation manual, September 23, 2004R0815009, September 23, 2004, PDF page 43 / printed page 37: Fastener and plug labels · checked 2026-09-13 · R0815009, September 23, 2004 · Rytec
- Rytec Bantam motorized operation manual, September 23, 2004R0815009, September 23, 2004, PDF page 51 / printed page 45: Nut-size conflict · checked 2026-09-13 · R0815009, September 23, 2004 · Rytec
| 0-551-325 | The manual-operation list describes #10 by0.75-inch TEK hardware; the motorized list describes #10-16 by0.5-inch Phillips pan-head hardware. This two-manual evidence does not resolve the conflicting specification.
|
|---|---|
| 0-553-103 | The manual-operation table prints1/2-20 UNC; the motorized table prints1/4-20. No corrected thread size or new definite fitment is approved.
|
| 0-704-006 | The dome-plug diameter is9/16 inch in the manual-operation table and0.53 inch in the motorized table. These measurements are not silently treated as equal or corrected.
|
| Resolve the installed configuration | Ask Rytec to resolve the exact hardware against the door serial and the applicable manual. Do not silently normalize the conflicting dimensions or substitute a nearby number.
|
Sources & review dates
- Rytec Bantam manual operation manual, May 25, 2000Rytec · US · checked 2026-09-13 · R0815007, May 25, 2000
- Rytec Bantam motorized operation manual, September 23, 2004Rytec · US · checked 2026-09-13 · R0815009, September 23, 2004
This independent reference preserves the source’s stated scope. It does not report an Anderson installation inspection, product test or safety clearance.
The cited sources define the product details shown here; comparison does not establish fitment. Anderson’s repair service covers its listed Connecticut communities; this national reference does not imply nationwide service.